Anodizing can cause a variety of problems. If you’re concerned about anodizing your paintball gun, you can try one of the following methods: Mix a solution of sulphuric acid and water. The mixture should be thick enough to coat the paintball gun part, but not so thick that it splashes. Depending on the size of the paintball gun part, you may need to mix more than one bucket of the solution.
Methods
One method for removing the anodizing from a paintball gun is to clean it thoroughly with soap and water. After cleaning, it should be rinsed in clean water to prevent oxidation. If the anodizing is stubborn, you can use steel wool to scrub the affected areas.
Anodizing is a protective coating applied to metals to make them more resistant to corrosion. However, this protective coating can fade over time and can result in nicks and scratches. Once this old finish is removed, you can polish the gun to a new finish.
Before you start the process, you will need to clean the parts. If they are not completely clean, the anodising process will fail. Using a rubber bucket, make sure the parts are completely clean. You should also wear rubber/nitrile gloves to protect your hands.
Damage caused by anodizing
There are a few steps involved in anodizing paintball guns. First, you have to make a solution of water and sulphuric acid. Care should be taken when pouring the solution so that the paintball gun part does not splash. Also, you must ensure that the water in the bucket is deep enough to cover the piece.
If you leave your paintball gun in an anodized state for too long, it will lose its original finish. This is because the anodizing process removes only a thousandth of an inch of the aluminum at a time. It also voids the manufacturer’s warranty on the modified component. Anodizing should be done by a professional service that has experience with paintball guns.
Recommendations for stripping anodizing
If you want your paintball gun to have a unique finish, you can have it anodized. The process involves immersing the gun parts in a solution containing sulphuric acid and water. The solution should be thick enough to coat the part.
You can also use a solution of caustic soda, or sodium hydroxide, to strip the anodic coating off your paintball gun. This is commonly found in drain cleaners, and it is a solution that reacts well with acids. However, you need to be careful not to over-strip your paintball gun because you could ruin its finish.
Anodizing changes the material’s dimensions. Before the process, the part is thinner, and the anodizing process raises the thickness of the part evenly. The problem with removing anodizing is that the process alters the material’s dimension, which can cause other problems.